CLI commands
snmp-server contact
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
snmp-server contact <email>
Specifies contact information.
no snmp-server contact
Deletes contact information.
Parameters
<email> Email address.
snmp-server heartbeat period
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
snmp-server heartbeat period <seconds>
Sets the interval between sending heartbeat traps.
Parameters
<seconds> Heartbeat interval in seconds.
snmp-server location
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
snmp-server location <name>
Specifies the location where the service controller is installed.
no snmp-server location
Deletes location information.
Parameters
<name> Location where the service controller is installed.
snmp-server port
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
snmp-server port <port number>
Sets the port the service controller will use to respond to SNMP requests.
Parameters
<port number> SNMP port number. Range 1 - 65535.
snmp-server readonly
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
snmp-server readonly <community>
Sets the read-only community string.
no snmp-server readonly
Deletes the read-only community string.
2-24
To Next Page
Loading...
Need help?
General
