CLI commands
firmware-update automatic
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
firmware-update automatic
Enables scheduled firmware upgrades.
no firmware-update automatic
Disables scheduled firmware upgrade.
The service controller can automatically retrieve and install firmware from a local or remote URL
at preset times. By placing service controller firmware on a web or ftp server, you can automate
the update process for multiple units.
When the update process is triggered the service controller retrieves the first 2K of the firmware
file to determine if it is different from the active version. If different, the entire firmware file is
then downloaded and installed.
(Different means older or newer. This enables you to return to a previous firmware version if
required).
Configuration settings are preserved during the update unless stated otherwise in the release
notes for the firmware. However, all active connections will be terminated. Users will have to log
in again after the service controller restarts
firmware-update start
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
firmware-update start
Upload the firmware based on a specified URI. This URI can be set with the command: firmware-
update uri.
firmware-update time
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
firmware-update time <time>
Sets the time of day the scheduled firmware upgrade will take place.
Parameters
<time> Time as hh:mm:ss. For example: 15:44:00.
firmware-update uri
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
firmware-update uri <uri>
Sets the URI where the service controller will retrieve new firmware.
no firmware-update uri
Clears the firmware URI.
2-32
To Next Page
Loading...
Need help?
General
