HP MSM7XX

CLI commands
no service controller discovery interface lan-port
Allow discovery on the LAN interface.
service controller primary
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
service controller primary
Become the Primary service controller.
no service controller primary
Become a secondary service controller.
service controller primary ip addr
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
service controller primary ip addr <ip address>
Configure a static ip address for the primary service controller.
service controller priority
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
service controller priority <number>
Sets the discovery priority of this device.
service controller provisioning
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
service controller provisioning
Enable the AP provisioning system.
no service controller provisioning
Disable the AP provisioning system.
bandwidth control internet-port
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
bandwidth control internet-port
Enables bandwidth control on the Internet port.
no bandwidth control internet-port
Disables bandwidth control on the Internet port.
bandwidth control internet-port high
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
bandwidth control internet-port high <min-tx-%> <min-rx-%> <max-tx-%> <max-rx-
%>
Sets the bandwidth rates (Tx minimum, Tx maximum, Rx minimum, and Rx maximum) for traffic
classed as High.
2-39