HP ProCurve 6120G/XG

Configuring IP Addressing
Configuring a Single Source IP Address
ProCurve(config)# show radius
Status and Counters - General RADIUS Information
Deadtime(min) : 0
Timeout(secs) : 5
Retransmit Attempts : 3
Global Encryption Key :
Dynamic Authorization UDP Port : 3799
Source IP Selection for the specified
application protocol is displayed.
Source IP Selection : Configured IP address
Figure 8-17. Example of show radius Command Displaying Source IP Selection Information
ProCurve(config)# show tacacs
Status and Counters - TACACS Information
Timeout : 5
Source IP Selection : Configured IP Interface
Encryption Key :
Source IP Selection for the specified
application protocol is displayed.
Figure 8-18. Example of show tacacs Command Displaying Source IP Selection Information
ProCurve(config)# show debug
Debug Logging
Source IP Selection: Configured IP interface
Destination: None
Enabled debug types:
None are enabled.
Source IP Selection for the specified
application protocol is displayed.
Figure 8-19. Example of show debug Command Displaying Source IP Selection Information for Syslog
8-27