HP ProCurve 6120G/XG Configuration Guide

Configuring IP Addressing
Configuring a Single Source IP Address
ProCurve(config)# show ip source-interface detail
Source-IP Detailed Information
Protocol : Tacacs
Admin Policy : Configured IP Interface
Oper Policy : Configured IP Interface
Source IP Interface : vlan 22
Source IP Address : 10.10.10.4
Source Interface State : Up
Protocol : Radius
Adm
in Policy : Configured IP Address
Oper Policy : Configured IP Address
Source IP Interface : vlan 3
Source IP Address : 10.10.10.2
Source Interface State : Up
Protocol : Syslog
Adm
in Policy : Configured IP Interface
Oper Policy : Configured IP Interface
Source IP Interface : vlan 10
Source IP Address
: 10.10.10.10
Source Interface State : Up
Protocol : Telnet
Adm
in Policy : Configured IP Interface
Oper Policy : Configured IP Interface
Source IP Interface : loopback 1
Source IP Address : 10.10.10.11
Source Interface State : Up
Protocol : Tftp
Adm
in Policy : Outgoing Interface
Oper Policy : Outgoing Interface
Source IP Interface : N/A
Source IP Address : N/A
Source Interface State : N/A
Protocol : Sntp
Adm
in Policy : Outgoing Interface
Oper Policy : Outgoing Interface
Source IP Interface : N/A
Source IP Address : N/A
Source Interface State : N/A
Figure 8-16. Example of Detailed Information Displayed for Each Protocol
The show command can also be used with the application to display the source
IP address selection information in effect for the application protocol.
8-26

HP ProCurve 6120G/XG Specifications

General

Brand	HP
Model	ProCurve 6120G/XG
Category	Switch
Language	English