HP ProCurve 6120G/XG

Troubleshooting
Viewing Switch Configuration and Operation
Syntax:
copy <source> show- tech
crash-log [slot-id | master]:
Includes the crash logs from all management and interface
modules in show tech command output.
event-log
Copies the contents of the Event Log to show tech command
output.
running-config
Includes the contents of the running configuration file in
show tech command output.
startup-config
Includes the contents of the startup configuration file in
show tech command output.
tftp config < startup-config | running-config > < ip-addr > < remote-file >
< pc | unix >
Downloads the contents of a configuration file from a
remote host to show tech command output, where:
ip-addr: Specifies the IP address of the remote host device.
remote-file: Specifies the pathname on the remote host for
the configuration file whose contents you want to include
in the command output.
pc | unix: Specifies whether the remote host is a DOS-based
PC or UNIX workstation.
For more information on using copy tftp commands, refer
to the “File Transfers” appendix.
Syntax:
copy <source> show- tech
xmodem config < startup-config | config < filename > | command-file
< filename.txt > < pc | unix >
C-68