Troubleshooting
Viewing Switch Configuration and Operation
Syntax:
copy <source> show- tech
Copies the contents of a configuration file from a serially
connected PC or UNIX workstation to show tech command
output, where:
startup-config: Specifies the name of the startup
configuration file on the connected device.
config <filename >: Specifies the pathname of a
configuration file on the connected device.
pc | unix: Specifies whether the connected device is a DOS-
based PC or UNIX workstation.
For more information on using copy xmodem commands,
refer to the “File Transfers” appendix.
C-69
To Next Page
Loading...
