NOTE: Click on any column heading to change the sort order or select which columns are
displayed.
Table 1 Service set parameters
DescriptionField
The name of the service setName
The node on which the service set is currently running. This is normally the same as the
Main node, unless a failover state has been invoked.
Current node
The name of the node on which the service set normally runs.Main node
The name of the failover node for the service set.Failover node
The status of the service set, such as: Running, Starting, Fault, Not Started, Stopped or
Unknown.
Status
Service sets
A service set is a collection of various services, such as VTL, NAS, Replication and StoreOnce
Catalyst. There is one instance of each service per service set. The auto-configuration process
registers and starts a service set by launching a process on the server for each of the services.
If you are an administrator, you will be able to create elements, such as libraries, NAS shares,
replication mappings and StoreOnce Catalyst stores for a service set. When you create such an
element, you will be asked to select the target service set to which it relates.
IMPORTANT: The number of service sets available depend upon the number of couplets in your
cluster configuration. The minimum number is 2 (for a single couplet in one rack), the maximum is
8 (for a two–rack installation with four couplets).
Service sets 13
To Next Page
Loading...
Need help?
General