System information and status
System information
This section provides the information that identifies your HP B6000 Backup System. It shows:
Table 4 System information parameters
DescriptionParameter
The type of server for the node on which the service set is running.Type
The node name for this service set.Node Name
The serial number of the node on which the service set is running (note: this serial number
is for internal use only, it is not the serial number that should be used when contacting
HP Support, see Important information about serial numbers (page 122))
Serial number
The VIF IP address for the service set. This is the IP address that you should use when
targeting backups and setting up replication mappings to this service set.
VIF IP
The software revision of the node on which the service set is running. Use this when
adding couplets to check that all service sets are running the latest and the same software.
Software revision
Status
This section provides details about the system status of the service set and the status of the services
running on that service set.
Table 5 Status parameters
DescriptionParameter
This is the overall system state of that service set.System
This is the status of the VTL service.Virtual Tape
This is the status of the NAS service.NAS
This is the status of the Replication service.Replication
This is the status of the StoreOnce Catalyst service.StoreOnce Catalyst
System information and status 15
To Next Page
Loading...
Need help?
General