File details tab
This tab displays mapping details for each directory and files within it. It includes average throughput
data for each file. You cannot edit any details on this tab, but you can click on any of the column
headings to sort the file details according to that column.
Running the replication wizard (NAS)
The Replication Wizard is used to create new mappings between Non-Replicating NAS shares
(which become Replication Source shares) and either existing or new Target shares. (See Recovering
a source appliance, NAS shares (page 115) for information about the Recovery wizard.)
1. Create a Non-Replicating Share on the Source Appliance.
2. Allow the first full backup to run.
3. Decide how you will seed the first full backup on the Target Appliance. (See also the HP
StoreOnce Backup System Concept Guide.)
• If you are seeding across the WAN or have been able to colocate the Target Appliance
on the same LAN as the Source Appliance, go to step 4.
• If you are seeding using physical media:
1. Create the first full backup on the Remote Site share.
2. Map to the NAS share on the Source Appliance and copy the files from the NAS
share to a USB disk.
3. Transport the USB disk to the replication target site.
4. Insert the USB disk into a host server on the same sub-net as the Target Appliance.
Map to the NAS Share on the Target Appliance and copy the files across from the
USB disk.
4. Go to the NAS Mappings page.
5. Select a Non-Replicating Share to be converted to a Replication Source Share and click Start
Replication Wizard.
6. Proceed to the Select Target Appliance step.
TIP: Click on the show/hide details link to check how many target appliances are permitted
and the number of target appliances that are currently configured.
NAS Mappings (Replication) 81
To Next Page
Loading...
Need help?
General