3. A report listing inbound copy jobs is displayed.
Table 19 Inbound copy job fields
The name of the item being copied to the inbound copy job.Item Name
The status of the job, which may be Pending, Running, Paused, Completed or Cancelled. (If it
shows as Cancelled and this action has not been instigated from the backup application or
Status
the Cancel Job button on the GUI, the data connection may have been lost between the HP
StoreOnce Backup System and the media server. This is unlikely to occur.)
Status information.Status Information
The amount of data in the copy job.Data Size
The copy speed.Copy Throughput
The address of the source server.Source Server
The name of the source store.Source Store
The name of the source item.Source Item Name
The client that initiated the outbound copy job.Client
The time the job was queued.Queued Time
The time the job started.Started Time
The time the job ended.Stopped Time
To cancel a copy job
It is recommended to cancel copy jobs via the backup application and only use the GUI as a last
resort. This ensures that the backup application catalog stays in sync with the backup images.
NOTE: If you use the GUI to cancel an inbound copy job, it is recommended to cancel the job
in the source outbound copy jobs list first.
1. Select the job to be cancelled in the inbound copy job list.
2. Click Cancel Job.
3. At the confirmation prompt click OK.
Troubleshooting
Since StoreOnce Catalyst is designed to allow maximum control to the client application, any
problems should be remedied by checking job configuration on the client. In the unlikely event that
the StoreOnce Catalyst Status display as Fault, contact HP support services for further advice.
Troubleshooting 59
To Next Page
Loading...
Need help?
General