9. As soon as reverse replication has completed, the data may be recovered to the host using
the original backup application.
10. New backups can now run to the Source Appliance and replication will run normally without
further configuration.
Figure 6 Reverse replication process: source lost
Promoting a Target Share over the WAN using NAS
The remote site has lost both the host servers and the StoreOnce system. New server hardware
has been purchased and installed and the administrator now wants to recover data to the server.
The administrator has not installed a new StoreOnce Backup System and is going to recover data
directly to the server from the Data Center StoreOnce appliance over the WAN (which will take
a long time).
NOTE: The procedure described below retains the ability to back up to the Target Share. If this
is not required, a simpler solution may be to recover data from the Target Share, which is read-only.
Recovering a Source Appliance (NAS shares) 119
To Next Page
Loading...
Need help?
General