EasyManuals Logo

HP StoreOnce B6000 Series User Manual

HP StoreOnce B6000 Series
153 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #135 background imageLoading...
Page #135 background image
Replacing a hot-plug hard disk
1. Identify the disk that has failed as described above.
NOTE: Remember you can use the Beacon LED to identify the physical disk in the storage
controller or expansion shelves.
2. Remove the disk.
Press the hard disk carrier button (1) to release the ejector lever.
Pull out the disk carrier handle (2) and slide the hard drive assembly (3) out of the drive
bay. Be sure to support the drive when pulling it out of the cage.
Figure 11 Removing the hard drive
3. Replace the failed disk with the new disk.
Push the hard drive assembly (1) into the drive bay until it stops and press the HDD carrier
latch (2) inward until it clicks.
Figure 12 Installing a replacement hard disk
Hard disk replacement 135

Table of Contents

Other manuals for HP StoreOnce B6000 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP StoreOnce B6000 Series and is the answer not in the manual?

HP StoreOnce B6000 Series Specifications

General IconGeneral
BrandHP
ModelStoreOnce B6000 Series
CategoryStorage
LanguageEnglish

Related product manuals