Partner Appliances (Replication)
The Partner Appliances tab shows you the replication status of all Target and Source HP StoreOnce
Backup Systems that have been configured for use with this HP StoreOnce Backup System.
There are three tabs; one for Target Appliances and one for Source Appliances, and a separate
tab for setting Source Appliance permissions.
Look at the bottom of the page to find information about any blackout windows that apply to the
selected appliance.
Target Appliances tab
The Target Appliances tab allows you to add, edit and remove Target Appliance details.
NOTE: Although you can add Target Appliances on this page, it is not necessary to do so before
mapping configurations because this option is also available when running the Replication wizard.
Summary Appliance details
The following status details are shown for both Target and Source appliances.
Table 21 Summary Appliance details
The name of the appliance.Appliance Name
The health of the appliance; this shows you whether the appliance is running.Appliance Status
The virtual IP address of the appliance.Appliance Address
The serial number of the appliance.Serial number
The amount of free space on the appliance.Free space
Whether the appliance is online.Online
The protocol of the appliance software.Protocol version
62 Replication
To Next Page
Loading...
Need help?
General