NOTE: When you select a Non-Replicating library, you will be able to run the Replication or
Recovering wizard.
• Use the Replication wizard to create slot mappings for the non-replicating library; it becomes
a Source library. See Running the replication wizard (virtual tape devices) for more information.
• Use the Recovery wizard to recover cartridges from a Target Library. See Recovering a source
appliance, VTL devices for more information.
Table 26 Local library parameters
The name of the library, defined when the library device was created.Name
The status of the local library (such as online)Library Status
The role, which may be non replicating, replication-source or replication-target.
All library devices are initially non replicating, until slots have been configured
using this page.
Replication role
The amount in GB of user data stored.User Data Stored
The amount of space used on the disk.Size on disk
The number of slots that have been mapped out of the total number of slots
configured on the library device.
Mapped/Total Slots
The emulation type configured for that library.Device Type
The longest time out of syncLongest Time out of Sync
The version number of the library.Library Version
Replication status, which may be Synchronised, Synchronising or Pending
Synchronisation.
Replication status
The service set on which the library is configured.Service set
Slot mappings
Select a local library to display slot mappings for that library.
Users with an Admin login may also remove a slot mapping by clicking on the Remove button.
Table 27 Slot mapping parameters
Replication-Source or Replication-Target library selected
This is the slot mapping name. Is it created when you run the wizard to define
the grouping of slots that you select.
Slot Mapping Name
The name of the Target Appliance to which cartridges will be replicated.Source/Target Appliance Name
The IP address of the Target Appliance to which cartridges will be replicated.Source/Target Appliance Address
This indicates whether a replication link is established with the partner
appliance.
Source/Target Appliance Online
The serial number of the Target Appliance to which cartridges will be
replicated.
Source/Target Appliance Serial Number
The name of the library to which cartridges will be replicated on the Target
Appliance .
Source/Target Library Name
The status of the partner library (such as online).Source/Target Library Status
Time in hours that replication has been out of sync.Time Out Of Sync
This relates to the local appliance in its role as a source or target appliance.
No replication jobs will be started if the source or target appliance for a
Blackout Window Active
VT Mappings (Replication) 73
To Next Page
Loading...
Need help?
General