NOTE: The above example shows the page layout when mappings have been created and a
Replication Source or a Replication Target share is selected. If a Non-Replicating Share is selected,
no mappings have been configured and the screen displays the Replication and Recovery Wizards.
Replication Shares
This section contains a list of all available NAS shares that have been configured on this HP
StoreOnce Backup System.
• Non Replicating: a share on this HP StoreOnce Backup System that has not yet been mapped
for replication. Replication and Recovering Wizards are available only with non-replicating
shares.
• Replication Source: a share on this HP StoreOnce Backup System that has been mapped for
replication.
• Replication Target: a share on this HP StoreOnce Backup System that has been replicated
from a Replication-Source share.
NOTE: When you select a Non-Replicating share, you will be able to run the Replication or
Recovering wizard.
• Use the Replication wizard to create slot mappings for the non-replicating share; it becomes
a Source share. See Running the replication wizard (NAS) (page 81) for more information.
• Use the Recovery wizard to recover files from a Target share. See Recovering a source
appliance, NAS shares (page 115) for more information.
Table 28 Local share parameters
The name of the share, defined when the share was created.Name
The status of the local share, such as online.Status
The role, which may be non-replicating, replication-source or replication-target.
All shares are initially non-replicating, until mappings have been configured
using this page.
Replication Role
NAS Mappings (Replication) 79
To Next Page
Loading...
Need help?
General