8. Install the type-p storage controller:
a. Install the type-p storage contoller (callout 1), and install the screw (callout 2).
Make sure that the controller is seated firmly in the slot.
b. Simultaneously push and rotate to close the riser cage latch (callouts 3 and 4).
9. Install the primary riser cage .
10. Cable the type-p storage controller .
11. To enable the FBWC feature of the storage controller, install an energy pack.
12. Install the access panel
13. Do one of the following:
Orient the server back in tower mode .
Install the server into the rack .
14. Connect all peripheral cables to the server.
15. Connect each power cord to the server.
16. Connect each power cord to the power source.
17. Power up the server.
18. Before using the controller for the first time, update the server and controller firmware if they are not the latest revision .
ResultsResults
The installation is complete.
Installing a type-o storage controllerInstalling a type-o storage controller
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have the following items available:
Compatible controller cable
T-10 Torx screwdriver
About this taskAbout this task
To Next Page
Loading...
