Installing the HPE NS204i Boot DeviceInstalling the HPE NS204i Boot Device
Installing the Installing the HPE NS204i Boot DeviceHPE NS204i Boot Device
PrerequisitesPrerequisites
Before you perform this procedures, make sure the following:
Fan 1 is installed
The server is updated with the latest operating system firmware and drivers.
Identify the HPE NS204i Boot Device components
Review the Limited operating inlet ambient temperature requirements for HPE NS204i Boot Device for a specific system
operating temperature requirement.
Before you perform this procedure, make sure that you have the following items available:
T-10 Torx screwdriver
T-15 Torx screwdriver
Phillips No. 1 screwdriver
ProcedureProcedure
Installing drives onto the Installing drives onto the boot deviceboot device
1. Remove the boot device carrier:
a. Press and hold the carrier latch (callout 1).
b. Pivot the latch to open (callouts 2).
c. Slide the carrier out from the boot device cage (callout 3).
2. Install the SSDs on the boot device carrier:
a. Remove the SSD mounting screw.
To Next Page
Loading...
