14. Connect the SATA-power Y-cable to the drive .
15. Connect the cables to the system board:
SATA-power Y-cable
Front I/O cables
16. Make sure that all the system cables that are routed through the front cable channel are properly secured in the metal cable tabs.
This is done to prevent system damage due to cables being inadvertently caught under the fan cage.
17. Install the fan cage.
18. Install the access panel
19. Do one of the following:
Orient the server back in tower mode .
Install the server into the rack .
20. Connect all peripheral cables to the server.
21. Connect each power cord to the server.
22. Connect each power cord to the power source.
23. Power up the server.
ResultsResults
The installation is complete.
Transceiver optionTransceiver option
Transceivers serve as the connection between the adapter and the network cable for maintaining high-speed performance.
SubtopicsSubtopics
Transceiver warnings and cautionsTransceiver warnings and cautions
Installing a transceiverInstalling a transceiver
To Next Page
Loading...
