USB RDX drives for an inexpensive and reliable way to securely store your data backups.
For RDX drive installation, see Installing a USB RDX docking station.
SubtopicsSubtopics
Installing an internal USB deviceInstalling an internal USB device
Installing an internal USB deviceInstalling an internal USB device
ProcedureProcedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. Do one of the following:
If the server is in tower mode, place the server on a flat, level surface with the access panel facing up .
If the server is in rack mode, remove the server from the rack .
5. Remove the access panel .
6. Plug in the USB device into the USB port.
7. Install the access panel
8. Do one of the following:
Orient the server back in tower mode .
Install the server into the rack .
9. Connect all peripheral cables to the server.
10. Connect each power cord to the server.
11. Connect each power cord to the power source.
12. Power up the server.
ResultsResults
The installation is complete.
CablingCabling
To Next Page
Loading...
