b. Push the energy pack down from other end (callout 2).
9. Connect the energy pack extension cable to the system board .
10. Connect the storage backup power cable .
11. If removed, install the HPE NS204i Boot Device .
12. Install the access panel
13. Do one of the following:
Orient the server back in tower mode .
Install the server into the rack .
14. Connect all peripheral cables to the server.
15. Connect each power cord to the server.
16. Connect each power cord to the power source.
17. Power up the server.
ResultsResults
The installation is complete.
Expansion card optionsExpansion card options
The server supports PCIe riser options for installing full-height, full-length, and full-height, half-length PCIe expansion / add-in (AIC)
cards such as::
HPE type-p storage controller
Ethernet adapter
HDR InfiniBand adapter
Fibre channel host bus adapter (FC HBA)
For more information on the expansion options validated for this server, see the server QuickSpecs on the Hewlett Packard Enterprise
website:
https://buy.hpe.com/us/en/p/1014696172https://buy.hpe.com/us/en/p/1014696172
To Next Page
Loading...
