Install the rack rails and server trayInstall the rack rails and server tray
About this taskAbout this task
The rack rails can be installed in a round-hole or a square-hole racks. The rack rails occupy 1U space in the rack.
ProcedureProcedure
1. Disassemble the rack rail assemblies:
a. Pull out the inner sliding rail until it is fully extended (callout 1).
b. Slide and hold the white release tab in the direction shown, and then remove the sliding rail from the mounting rail (callout 2).
2. Install the sliding rails on the server tray:
a. Insert the spools on the sides of the server through the notches on the rails (callout 1).
b. Slide the rail towards the rear of the tray to lock it into place (callout 2).
To Next Page
Loading...
