card installation.
This slot supports an OCP NIC adapter.
This slot supports an OCP NIC adapter or a type-o storage controller.
Primary/secondary riser cage supports two riser boards.
SubtopicsSubtopics
Display device setupDisplay device setup
Display device setupDisplay device setup
This server supports both VGA port and DisplayPort 1.1a. Before connecting a display device to this server, review the information
below.
Whenever possible, use the same display connection type. For example, if your PC or monitor only has a VGA output, connect it to
the server VGA port. Use of any kind of adapter or converter cable or dongle might lead to decreased display quality or a lag over
the connection.
DisplayPort connection: When connecting an HDMI or DVI display to the DisplayPort, use an active type adapter. Passive type
adapter—marked with the DP++ symbol—is not supported.
Display output modes:
If you connect two display devices to the VGA port and DisplayPort, the same image is shown on both devices—screen
mirroring mode.
The embedded video controller in the iLO 6 chipset does not support dual display or screen extension mode. To enable dual
display mode, install a compatible PCIe graphics card that supports this feature in the expansion slot.
Rear panel LEDsRear panel LEDs
2
3
4
To Next Page
Loading...
