8. Make sure that any switches or jumpers on the expansion card are set properly.
For more information, see the documentation that ships with the expansion card option.
9. Install the expansion card:
a. Install the expansion card (callout 1), and install the screw (callout 2).
Make sure that the expansion card is seated firmly in the slot.
b. Simultaneously push and rotate to close the riser cage latch (callouts 3 and 4).
10. Connect all necessary internal cabling to the expansion card.
For more information on these cabling requirements, see the documentation that ships with the option.
11. Install the riser cage.
12. Install the access panel
13. Do one of the following:
To Next Page
Loading...
