a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. Do one of the following:
If the server is in tower mode, place the server on a flat, level surface with the access panel facing up .
If the server is in rack mode, remove the server from the rack .
5. Remove the access panel .
6. Remove the fan cage.
7. Remove the secondary riser cage.
8. Remove the protective film from the thermal interface material.
9. Set the anti-tilt wires to the locked position.
To Next Page
Loading...
