4. Disconnect all peripheral cables from the server.
5. Do one of the following:
If the server is in tower mode, place the server on a flat, level surface with the access panel facing up .
If the server is in rack mode, remove the server from the rack .
6. Remove the access panel .
7. Remove the fan cage.
8. Disconnect the front I/O cables from the system board .
9. Remove the optical drive cage:
a. Remove the optical drive cage screws (callout 1).
b. Slide the optical drive cage out of the server (callout 2).
10. Remove the optical drive blank:
a. Use a plastic spudger to pry one side of the blank (callout 1).
b. Remove the optical drive blank from the optical drive cage (callout 2).
11. Install the optical drive bracket.
To Next Page
Loading...
