Before removing the ground cables and cabinet doors, remove the marking-o template
and concrete mounting kits.
1. Remove the ground cables from the front door and rear door. One end of the
ground cable is connected with the cabinet door.
2. Pull down the hook pin at the upper part of the door panel.
3. Remove the front door.
4. Follow the same steps to remove the rear door.
Figure 4-18 Removing the ground cables and doors
For the coming use, put away the front and rear doors of the cabinet and bolts.
Determining the Installation Position of the Supports
1. Positioning the cabinet.
Figure 4-19 Positioning the cabinet
The spacing between the rear door of the front access cabinet and the wall or any
other obstacles should be no less than 100 mm.
2. Determining installation holes for the cabinet.
a. Lay out the templates side by side and ensure that there is 600 mm
between the center lines of two adjacent templates.
HUAWEI NetEngine 8000 F
Hardware Guide 4 Hardware Installation and Parts Replacement
Issue 05 (2023-03-31) Copyright © Huawei Technologies Co., Ltd. 363
To Next Page
Loading...
Need help?
General
