A. Jacket of
connector
B. Metal shell of
connector
C. Wire holder of
connector
D. Plug of
connector
E. Jacket of
Ethernet cable
F. Shield layer of
Ethernet cable
G. Twisted-pair
wires
-
Procedure
1. Fit the jacket of the connector onto the Ethernet cable, as shown in Figure
4-104.
Figure 4-104 Fitting the jacket of the connector onto the Ethernet cable
2. Remove a 30 mm (1.18 in.) long section of the jacket, cut o the nylon twine
inside the jacket, and cut a no more than 5 mm (0.20 in.) cleft in the jacket,
as shown in Figure 4-105.
Figure 4-105 Removing the jacket of a twisted-pair cable (unit: mm (in.))
● When you remove a section of the jacket, do not damage the shield layer
of the twisted-pair cable.
● When you remove the shield layer, do not damage the insulation of the
twisted-pair cable.
HUAWEI NetEngine 8000 F
Hardware Guide 4 Hardware Installation and Parts Replacement
Issue 05 (2023-03-31) Copyright © Huawei Technologies Co., Ltd. 459
To Next Page
Loading...
Need help?
General
