● Be careful not to damage components and cables in the cabinet during
transportation.
● If the cabinet surface is scratched, paint the scratched area with the same
painting as the other part to protect the cabinet.
● Conduct a comprehensive inspection on the cabinet before the installation. If
you
nd the cabinet distorted or its surfaces damaged, contact technical
support personnel immediately.
● Follow the installation instructions provided in this document and make
adjustments according to actual situations in your installation site.
Procedure
Step 1 Unpack and inspect the cabinet and accessories. The accessories include the
cabinet stand and expansion bolts used to secure the cabinet to the
oor.
Step 2 Inspect the space inside and around the cabinet.
● Enough space must be reserved at the lower part of the cabinet for installing
expansion bolts.
● There must be enough space around the cabinet installation area for
operation and ventilation.
----End
Assembling the Cabinet Stand
Procedure
Step 1 Adjust the height of the cabinet stand.
1. Measure the distance between the concrete
oor and surface of the ESD oor
with a measuring tape, as shown in Figure 4-195.
HUAWEI NetEngine 8000 F
Hardware Guide 4 Hardware Installation and Parts Replacement
Issue 05 (2023-03-31) Copyright © Huawei Technologies Co., Ltd. 535
To Next Page
Loading...
Need help?
General
