Huawei UPS2000-H - Logging in to the App

Prerequisites
● A mobile phone running Android 8.0, Harmony 2.0, or iOS 9.0 or later is
available.
● The mobile phone can connect to the Internet.
● The mobile phone is within 10 m of the UPS.
Procedure
Step 1 Scan the QR code on the UPS panel using the mobile phone.
Figure 6-2 Scanning the UPS QR code
Step 2 (Optional) Select a display language.
Step 3 Download and install the app using either of the following methods.
● Download and install the NetEco app using a web browser.
● Download and install the NetEco app from Huawei AppGallery.
----End
6.2.1.2.2 Logging In to the App
NO TE
● A maximum of two mobile phones can be connected to the WiFi network, and only one
mobile phone can be used to log in to the app.
● When logging in to the app, select Allow for all permission dialog boxes displayed on
the mobile phone.
● When connecting the mobile phone to the WiFi network of the UPS, it is recommended
that you disable the WLAN+ function on the phone. Enabling the WLAN+ function will
let the mobile phone automatically connect to the network with the strongest signal,
which may result in UPS WiFi connection failure.
● GPS should be enabled on the mobile phone to obtain the WiFi name.
● For the rst login, you need to enter the WiFi password.
● After the UPS is powered on, the WiFi indicator turns on, and WiFi is enabled by default.
Step 1 Enable WiFi on your phone. (The WiFi icon turns on.)
UPS2000-H-(6 kVA-10 kVA)
User Manual 6 Power-On Commissioning
Issue 03 (2023-08-20) Copyright © Huawei Digital Power Technologies Co., Ltd. 99