Figure 5-43 Installing rubber plugs
----End
5.3.3 Installing Cables
● Stay away from the equipment when preparing cables to prevent cable scraps
from entering the equipment. Cable scraps may cause sparks during power-on
and result in personal injury and equipment damage.
● Use the terminals delivered with the UPSs or purchase right-angle terminals.
Do not bend common terminals to prepare cables.
● Prepare terminals onsite. The stripped length of the cable insulation layer
should be the same as that of the part of the terminal that covers the
conductor.
● When stripping the insulation layer of the power cable, do not damage the
conductor of the power cable.
● Do not use a heat gun to heat the heat shrink tubing for an extended period.
Ensure that the heat shrink tubing is tightly connected to the connector to
avoid damaging the insulation layer.
● After installing cables, clean the top, bottom, and wiring terminals of the UPSs.
Ensure that there is no dust or scraps around the UPSs.
Cables are installed in the same way for the 6 kVA and 10 kVA models. This
section uses the 6 kVA model as an example.
UPS2000-H-(6 kVA-10 kVA)
User Manual 5 Installation and Cable Connection
Issue 03 (2023-08-20) Copyright © Huawei Digital Power Technologies Co., Ltd. 79
To Next Page
Loading...
