● The Mobile Phone Number in Alarm Notication can be selected only after it
is added in SMS Settings.
● If you enable alarm notication by SMS message, when there is an alarm, the
system will send SMS messages to the receiver at 00:00, 06:00, 12:00, and
18:00. If the SNMP card is powered on within one hour after any of those six
time points, the system will check whether the alarm notication has been sent
at the previous time point after power-on. If the notication has not been sent,
the system will send it. If the notication has been sent, the system will not
send it again. If the SNMP card is powered on more than one hour after any of
those six time points, the alarm notication will not be sent until reaching the
next time point.
● Alarm sending example: If the SNMP card is powered on between 6:00 and
6:59, the system will check whether the alarm notication has been sent at
6:00. If it has been sent, the system will not send it again. If it has not been
sent, the SNMP card will send it. If the SNMP card is powered on between 7:00
and 11:59, the alarm notication will not be sent until 12:00.
----End
8.8 How Do I View Alarms?
Tap . The Current Alarms screen is displayed.
Figure 8-5 Alarms screen
Table 8-1 Alarm
Item
Description
Current Alarms Current alarms in the system are ltered by date. You can tap
an alarm to view alarm details, such as the alarm cause and
repair suggestion.
Historical
Alarms
Historical alarms in the system are ltered by date. You can
tap an alarm to view the alarm details, such as the alarm
cause and repair suggestion.
UPS2000-H-(6 kVA-10 kVA)
User Manual 8 FAQs
Issue 03 (2023-08-20) Copyright © Huawei Digital Power Technologies Co., Ltd. 134
To Next Page
Loading...
Need help?
General