Step 6 Tap OK as prompted. The Change Password screen is displayed. After the preset
password is changed successfully, use the new password to log in to the app.
Figure 6-9 Changing password prompt
● After the initial login, change the password in time to improve account security
and prevent data tampering.
● Hold down the RESET button on the UPS rear panel for about 10s to restore
the preset WiFi password, preset user password, and SNMP card (if any) IP
address. Other parameters will not be restored.
----End
6.2.1.2.3 Quick Settings
Step 1 After the login is successful, set parameters on the displayed Quick Settings
screen.
1. Verify the voltage level and frequency level based on site requirements.
2. Set the battery type, single battery voltage, number of batteries in a battery
string, single battery capacity, and number of battery strings based on site
requirements.
Figure 6-10 Quick Settings
UPS2000-H-(6 kVA-10 kVA)
User Manual 6 Power-On Commissioning
Issue 03 (2023-08-20) Copyright © Huawei Digital Power Technologies Co., Ltd. 102
To Next Page
Loading...
