● You change the battery use scenarios without notifying the Company.
● You connect extra loads to the batteries.
● The battery storage period has exceeded the upper limit.
● The battery warranty period has expired.
General Requirements
This is a category C2 battery product. In a residential environment, this product
may cause radio interference, in which case the user may be required to take
additional measures.
To ensure battery safety and battery management accuracy, use batteries provided
by the Company. The Company is not responsible for any battery faults caused by
batteries not provided by it.
● Before installing, operating, and maintaining batteries, read the battery
manufacturer's instructions and comply with their requirements. The safety
precautions specied in this document are highly important and require
special attention. For additional safety precautions, see the instructions
provided by the battery manufacturer.
● Use batteries within the specied temperature range. When the ambient
temperature of the batteries is lower than the allowed range, do not charge
the batteries to prevent internal short circuits caused during low-temperature
charging.
● Do not reversely connect the positive and negative battery terminals.
Otherwise, a battery alarm will be generated and batteries may be damaged.
● Before unpacking batteries, check whether the packaging is intact. Do not use
batteries with damaged packaging. If any damage is found, notify the carrier
and manufacturer immediately.
● In an indoor scenario, you are advised to power on a battery within seven
days after unpacking. If the battery cannot be powered on in time, put it in
the original packing case and place it in a dry indoor environment without
corrosive gas.
● Do not use a damaged battery (such as damage caused when a battery is
dropped, bumped, bulged, or dented on the enclosure), because the damage
may cause electrolyte leakage or ammable gas release. In the case of
electrolyte leakage or structural deformation, contact the installer or
professional O&M personnel immediately to remove or replace the battery.
Do not store the damaged battery near other devices or ammable materials
and keep it away from non-professionals.
● Before working on a battery, ensure that there is no irritant or scorched smell
around the battery.
UPS2000-H-(6 kVA-10 kVA)
User Manual 1 Safety Information
Issue 03 (2023-08-20) Copyright © Huawei Digital Power Technologies Co., Ltd. 9
To Next Page
Loading...
Need help?
General