GSP9700 Series Road Force Measurement System Operation 3. Mounting Wheels on the Balancer 31
Position the valve stem at 12 o’clock, and then press “Enter Valve Stem.”
After measuring rim runout, you will be prompted to loosen the wheel and re-clamp at
one half turn (approximately 180 degrees) from the current position.
Place the inner arm against the rim as shown.
Press the outer arm button or “Start” when ready to take readings.
Once more, position the valve stem at 12 o’clock, and then press “Enter Valve Stem.”
If the rim is centered properly, the following screen will appear briefly.
To Next Page
Loading...
