32 3. Mounting Wheels on the Balancer GSP9700 Series Road Force Measurement System Operation
The GSP9700 will then proceed to the “Balance” screen.
If a centering problem is detected, the following screen will appear.
The procedure will repeat the re-centering check up to four times and always
compare the previous measurement to the next check. If centering is not achieved
after four attempts, the following screen will appear.
Check for:
Correct mounting cone/adaptor for this wheel design.
Wheel defect such as a metal burr interfering with the
cone/adaptor.
Dirt or debris interfering with the cone/adaptor.
Follow the on-screen prompts, and then press “Restart Procedure.”
To Next Page
Loading...
