Husky Altanium Matrix5 - Set the Remote Boost Delay Timer; Change the Remote Boost Input Mode

Set the Remote Boost Delay Timer 133
User Guide v 1.0 — February 2020 System Setup
To set the Remote Boost Duration Timer, do the steps that follow:
1. On the System Setup screen, touch the Heats Setup tab and then touch the Control
Page 1 tab.
2. Touch the Remote Boost Duration Timer field that is below Remote Boost.
3. Enter the time requirement in this format: HHMMSS.
4. Touch the Accept button.
10.18.3 Set the Remote Boost Delay Timer
Use the Remote Boost Delay Timer to wait for a specified period before the system enters
boost mode.
To set the Remote Boost Delay Timer, do the steps that follow:
1. On the System Setup screen, touch the Heats Setup tab and then touch the Control
Page 1 tab.
2. Touch the Remote Boost Delay Timer field that is below Remote Boost.
3. Enter the time requirement in this format: HHMMSS.
4. Touch the Accept button.
10.18.4 Change the Remote Boost Input Mode
The Remote Boost Input Mode setting is enabled by one of three settings: Trigger, On/Off, or
Direct.
NOTE: If remote boost is not installed on the system, the Remote Boost Input Mode field will
not show on the screen.
To change the Remote Boost Input Mode, do the steps that follow:
1. On the System Setup screen, touch the Heats Setup tab and then touch the Control
Page 1 tab.
2. Touch the Remote Boost Input Mode field that is below Remote Boost.
3. Touch mode in the list to select it.