Clean the System 229
User Guide v 1.0 — February 2020 Maintenance
15.6 Clean the System
15.6.1 Cabinet (Mainframe)
To clean the cabinet, de-energize the system, disconnect it from the main power, and do
what follows:
• Use a damp sponge or cloth. Do not use abrasives on the surface. The labels should also
be wiped and no cleaners or solvents should be used.
• If a cleaner of any type must be used, a non-ammonia, non-alcohol window cleaner
sprayed onto a cloth, not directly onto the cabinet, is recommended.
15.6.2 Touch Monitor
To clean the touch screen, do the steps that follow:
1. Make sure the monitor is de-energized.
2. Wipe the screen with a clean, soft, lint-free cloth. This removes dust and other particles.
3. If necessary, apply a small amount of non-ammonia, non-alcohol based glass cleaner
onto a clean, soft, lint-free cloth, and wipe the screen.
WARNING!
Electrical and mechanical hazard- risk of death, serious injury and/or damage to the
equipment. Turn off all power to the system and disconnect it completely from the
main input power.
Hazardous voltages– risk of death or serious injury. Before you do service on the
Altanium unit, lock-out and tag the Altanium Main Power switch in accordance with
local codes.
CAUTION!
Mechanical hazard - risk of damage to the equipment. Do not spray or pour any liquid
directly onto the screen or case. Spray cleaner onto a lint-free cloth. If droplets are
allowed to dry on the monitor permanent staining or discoloration may occur.
CAUTION!
Mechanical hazard - risk of damage to the equipment. The display area is highly prone
to scratching. Do not use ketone type material (e.g. acetone), ethyl alcohol, toluene,
ethyl acid or methyl chloride to clear the panel. These products may permanently
damage the panel and void the warranty.