v 1.0 — February 2020 Altanium Matrix5
48 Make a New Mold Setup File
6.1.2 Make a New Mold Setup File
When a mold setup folder has been created, a new mold setup file can be added to it.
When a new mold setup file is created, and the Default folder contains only the Default mold
setup file, the factory default setup file is copied and used as a template to build the new
mold setup file.
If the Default folder contains a user-supplied setup file named “New Setup”, the new setup
file that is made would be a copy of the “New Setup” file. To make a “New Setup” file, copy a
setup file, rename the file to “New Setup”, and then copy the new file to the Default folder.
This gives the user a specified template for all new setup files as an alternative to the factory
default.
To create a new mold setup file, do the steps that follow:
1. On the Mold Setup screen, touch the desired mold folder.
2. Touch the New Mold Setup button. A dialog box will open.
3. Enter the name of the new mold setup.
4. Touch the Accept button.
6.1.3 Save Changes to a Mold Setup File
After a mold setup file has been loaded, all changes made to the file can be permanently
saved.
To permanently save changes to a mold setup file, do the steps that follow:
1. On the Mold Setup screen, touch the Save Changes button. The Mold Setup - Save
dialog window shows, so you can make sure the mold and file name in which the
changes are to be saved are correct.
2. Touch the Accept button.
All changes are permanently saved to the loaded mold setup file.
6.1.4 Discard Changes to a Mold Setup File
All changes to a mold setup file are held in the system's data base until they are permanently
saved or discarded. When changes are discarded, the mold setup file goes back to the state
it was in after the last save was done.
To discard changes to a Mold Setup file, do the steps that follow:
1. On the Mold Setup screen, touch the Discard Changes button. The Mold Setup -
Discard dialog window shows so you can make sure that the mold and file name that the
changes are to be discarded are correct.
2. Touch the Accept button.
All changes are permanently discarded from the loaded mold setup file.
To Next Page
Loading...
Need help?
General
