Load a Mold Picture View Graphic 149
User Guide v 1.0 — February 2020 Mold Picture View
5. Touch the Select File Name button.
6. Touch one of the file location buttons that follow:
• Local - to navigate to a graphic file stored on the Altanium.
• Network - to navigate to a graphic file stored on a network.
• USB - to navigate to a graphic file stored on a USB drive.
7. Navigate to where the image is stored.
8. Select the image.
9. Touch the Accept button.
NOTE: To automatically increase the size of the image to fill the Mold Picture View
screen, touch the Auto Fit Image check box so the check mark shows.
10. Touch the Accept button.
Figure 11-2 Change View Settings Dialog Window
1. Select File Name Button 2. Image File Name Field 3. Auto Fit Image Check Box 4. First
Selection Field 5. Second Selection Field 6. Zone Number
1