Husky Altanium Matrix5 User Manual

v 1.0 — February 2020 Altanium Matrix5
172 Data Collection Stop Conditions
Yes Yes Yes Yes If pair of digital inputs (start and end):
• End digital input does not go high before the
cycle time limit has expired
• Heats are turned off or not At Temperature
• UltraSync-E is disengaged or disabled
• Mold Servo Controller is disengaged or
disabled
System changes to timed data collection
If one digital input to start and timer to end data
acquisition:
• Start digital input is not high again before the
cycle time limit has expired
• Heats are turned off or not At Temperature
• UltraSync-E is disengaged or disabled
• Mold Servo Controller is disengaged or
disabled
System changes to timed data collection
If one digital input to start and end data
acquisition:
• Start digital input does not go high again
before the cycle time limit has expired
• Heats are turned off or not At Temperature
• UltraSync-E is disengaged or disabled
• Mold Servo Controller is disengaged or
disabled
System changes to timed data collection
Table 12-5 Cycle Mode - Conditions to Stop (UltraSync-E or Altanium Servo Control Installed) (Continued)
Heats Running
Condition
Enabled
UltraSync-E
Engaged
Condition
Enabled
Mold Servo
Controller
Engaged
Condition
Enabled
Cycle Mode
Conditions
Selection Shown
on Screen
Conditions to Stop

Husky Altanium Matrix5 Specifications

General

Brand	Husky
Model	Altanium Matrix5
Category	Controller
Language	English