Altanium Matrix5
ii v 1.0 — February 2020
Issue: v 1.0 — February 2020
This product manual is intended to provide information for safe operation and/or
maintenance. Husky reserves the right to make changes to products in an effort to
continually improve the product features and/or performance. These changes may result in
different and/or additional safety measures that are communicated to customers through
bulletins as changes occur.
This document contains information which is the exclusive property of Husky Injection
Molding Systems Limited. Except for any rights expressly granted by contract, no further
publication or commercial use may be made of this document, in whole or in part, without
the prior written permission of Husky Injection Molding Systems Limited.
Notwithstanding the foregoing, Husky Injection Molding Systems Limited grants permission
to its customers to reproduce this document for limited internal use only.
Husky® product or service names or logos referenced in these materials are trademarks of
Husky Injection Molding Systems Ltd. and may be used by certain of its affiliated companies
under license.
All third-party trademarks are the property of the respective third-party and may be
protected by applicable copyright, trademark or other intellectual property laws and treaties.
Each such third-party expressly reserves all rights into such intellectual property.
© 2019 Husky Injection Molding Systems. All rights reserved.
To Next Page
Loading...
Need help?
General
