Figure 6-32: Routing the wires
1. Nozzle Retainer 2. Nozzle Retainer Wire Passage 3. Wire Channel
8. Install the nozzle retainer but do not tighten it.
9. Route the wires into the wire channel on the manifold frame. Make sure all wiring is properly
retained in the wire channel using wire clips.
10. Tighten the nozzle retainer.
11. Make sure to stagger the knuckles in the wire grooves.
Hot Runner Installation Manual v 2.2 — March 2021 Maintenance
Removing and Installing Nozzle Heaters 91
To Next Page
Loading...
