English - 61
5.2.4 Assembling the display cover
When assembling: Make sure parts are
clean and that no cables will be pinched.
An unsealed chassis can let in moisture,
which can result in faults in the mower.
Always use new sealing strips before
putting the chassis halves or the display
cover together. A sealing strip that has
already been used does not provide
a satisfactory seal.
IMPORTANT INFORMATION
1. Fit a new sealing strip to the upper section
of the chassis. See 5.22 Assembling the
sealing strip on page 77
Note! In order to obtain adequate sealing,
it is important that the ends of the sealing
strips are laid on top of each other and not
next to each other.
2. Fit the display cover on the chassis. Check
that no cables are pinched between the
chassis and the display cover. When
assembling it is important to rst feed as
much as possible of the cables down into
the chassis and then t the display cover on
the chassis.
3. Screw the display cover and the chassis
together using the four screws (Torx 20).
The screws should be tightened crosswise.
4. Fit the HMI cable to the HMI circuit board.
5.2.5 Assembling the chassis
When assembling: Make sure parts are
clean and that no cables will be pinched.
An unsealed chassis can let in moisture,
which can result in faults in the mower.
Always use new sealing strips before
putting the chassis halves or the display
cover together. A sealing strip that has
already been used does not provide
a satisfactory seal.
IMPORTANT INFORMATION
Fit a new sealing strip to the lower section
of the chassis and to the cutting disc
housing. See 5.22 Assembling the sealing
strip on page 77.
5. REPAIR INSTRUCTIONS
TH_1158203_310_315_GARDENA_US.indd 61 2016-05-11 10:16:25
To Next Page
Loading...
