Hypertherm HyPerformance Plasma HPR400 User Manual

InstallatIon
HPR400XD Auto Gas – 806160 3-25
5
6
5
6
Note: The inductor on the pump motor drive board makes a noise during operation that has been
described as a “hum”, “sing”, and “click”. This is normal and can be disregarded.
See note below

Hypertherm HyPerformance Plasma HPR400 Specifications

General

Duty Cycle	100% at 400 A
Cutting Capacity	up to 50 mm (2 in)
Output Current	30-400 A
Input Voltage	200 – 480 V, 3-PH, 50/60 Hz
Gas Supply	Oxygen, Air, Nitrogen