Chapter 3 Operation
61
Chapter 3 Operation
3.1 Types of Operations
The MSEL controller is a programming controller that can operate without a host controller.
Programming for this controller uses IAI’s dedicated programming language (SEL language).
[Refer to the separate SEL Language Programming Manual.]
Operation method
Operation in a standalone
(independent) mode
[Refer to the 3.4.1 Auto Start
upon Power On]
Operation via PIO interface
Operation via serial
communication commands
Operation using a teaching tool
Operation with PIO (24V I/O)
[Refer to the 3.4.2 Starting a Program by Specifying its
Program Number]
Operation with Fieldbus communication (option)
(DeviceNet, CC-Link, PROFIBUS-DP, EtherNet/IP,
EtherCAT and PROFINET-IO are supported.)
[Refer to the separate operation manual for each Fieldbus
protocol.]
Operation with Serial communication (RS232C)
[Refer to the separate SEL language programming manual.]
Operation with Ethernet communication (option)
[Refer to the separate Ethernet operation manual.]
To Next Page
Loading...
Need help?
General
