Profiler View
105
The Crosshair
Figure 84. The Crosshair
The crosshair appears when the Show Crosshair menu item is checked (the
default). When the pointer hovers above the profiler graphic, a crosshair is
shown to indicate the sample value at that location and the distance to the
origin. See Figure 84.
Press the Ctrl key to change the crosshair into a horizontal line that follows
the mouse vertical position. You can use this to determine the optimal sensor
values.
NOTE: Set the zoom factor to display the entire graph for this feature. See
“Zoom” on page 106.
To Next Page
Loading...
