178
Chapter 5 Patterns / Variables
Variable Tab
Use Variable tab to define variables. Use a variable to store data from the
host so that it can be used at a later time. To define a variable, enter the name
of the variable and add it to the Variable List. To store data into the variable
use the Store mode (page 157). To clear the content of all defined variables
use the Reset All Variables mode (page 157).
Figure 159. Variable Tab
Name: The name of the variable. This name appears in pop-up menus where
you insert and use variables.
Variable List
Lists all the variables that you have defined and added to the list.
New: Click New to clear the Name field.
Add: Click Add to add the named variable to the end of the Variable List.
NOTE: The name of the variable must be unique.
Edit: Select an item in the Variable List, and click Edit to copy its name into
the Name field.
NOTE: If you select more than one item, only the name of the first item will
copy into the Name field.
Remove: Select one or more items in the Variable List, and click Remove to
remove them from the list.
IMPORTANT
Removing variables invalidates entries that use the variables.
To Next Page
Loading...
Need help?
General
