Configure Macro
143
Enable Remote Printer Management
This sets the printer’s diagnostic port to Ethernet, without having to navigate
through the printer’s operator panel.
It performs the following in the background:
1. Opens a command prompt session.
2. Executes a telnet command to the printer’s IP address.
3. Logs in as root.
4. Executes the enable printermgr telnet command.
5. Closes the command prompt session.
NOTE: You must have Telnet root privileges to use this utility. See “Telnet
Root Password” on page 58.
Select Utilities
Enable Remote Printer Management, and the following
dialog box opens:
Figure 123. Enable Remote Printer Management Dialog Box
Click Yes to continue.
When remote printer management has been enabled, the following dialog box
opens:
Figure 124. Remote Printer Management Enabled
To Next Page
Loading...
Need help?
General
