132
Chapter 4 Set Wireless Properties
Kerberos Tab
The Kerberos tab contains four sub-tabs: Print Server, KDC, Set Password,
and Credentials.
Figure 110. Wireless Properties:
Kerberos Tab – Print Server Sub-Tab
Print Server Sub-Tab
You must click Read to obtain the printer’s settings before you can modify
them.
NOTE: If the Ethernet Interface has a password assigned to the user guest,
then a Telnet guest password is required. See “Security Tab” on
page 58.
Status: Displays Authenticated or Not Authenticated once an attempt to send
Kerberos information has been sent.
Activate Kerberos: Check this check box to have the printer use Kerberos
when the printer is using a wireless connection.
Renewable Lifetime/Units: The maximum allowable renewable lifetime in
seconds, hours, or days. The range is 300 seconds to 3 days, or 0 (i.e., no
limit). The default is 0.
Print Server Name: The name of the print server.
When you are finished, click Send to transmit the values to the printer.
NOTE: If the Ethernet Interface has a password assigned to the user root,
then a Telnet root password is required. See “Security Tab” on
page 58.
If you are not going to modify settings on any other tabs, you must update the
printer for the settings to take effect. Click Update to update the printer.
IMPORTANT
Make sure the settings match those configured in the Access Point.
To Next Page
Loading...
Need help?
General
